HyperX Fury Black 4GB, DDR3, 1600MHz (PC3-12800), CL10, DIMM Memory

Description

Specification

  • Series: Kingston HyperX Fury
  • DDR Type: DDR3
  • Size: 4GB
  • Speed: 1600 MHz
  • Compliance: PC3-12800
  • Pins: 240-pin
  • CAS Latency: CL10
  • Data Integrity Check: Non-ECC
  • Voltage: 1.5V
  • Timings: 10-10-10-30
  • Heatsink: Yes
  • #Hide#LED Lighting: No
  • Package Type: Blister Pack
  • Package Weight: 0.0500 kg
  • Warranty: Lifetime
£25.75
Qty:
HX316C10FB/4 
4GB 512M x 64-Bit DDR3-1600 CL10 240-Pin DIMM
 
HyperX HX316C10FB/4 is a 512M x 64-bit (4GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 1Rx8 memory module, based on eight 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. 
 
 
 
Features
 
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), single sided component
  • Availability: In Stock
  • Model: D3-4G1600KHX10-FUBLK
  • Manufacturer: HYPERX

Write Review

Note: Do not use HTML in the text.
Back to top